2020 DMC Eurosystem M2 1350

AUTOMATIC LAPPING MACHINE CALIBRATOR DMC EUROSYSTEM M2 1350

LINEAR MACHINE

Control with integrated PC "EYE-M" and electronic control "Maestro Pro-Sand"

BASEMENT

Fixed part passage height at 900 mm from ground

Main engines inside the base

*Window with illuminated porthole from the tape introduction side

LED lights for internal illumination

TRANSLATION_ADVANCEMENT_TABLE

Conveyor belt advance with 3kW motor controlled by INVERTER

Automatic centering device for the conveyor belt

Motorized roller at exit on the floor / Conveyor belt

Useful working widths 1350 mm

Minimum and maximum workable thickness 3 ÷ 170 mm

Feed rate from 3.5 to 18 m/min

60Sh rubber belt conveyor

*Floor and perforated mat prepared for the depressor

Inverter-powered depressor, integrated into the base

OPERATOR GROUPS

Oscillation of belts with electronic control

Automatic disk brakes for rapid stopping of groups

EMERGENCIES / SAFETIES

Entrada piece debris conveyor guarding band

Front and rear mushroom head emergency switch

General lockable switch

* Automatic emergency stop of the machine in case of:

- breakage of the abrasive belt

- untensioned abrasive belt

- lateral leakage of the abrasive belt

- opening of access doors to operator groups

- lack of compressed air

- motor overload

On-board machine control panel

1st OPERATOR GROUP

TA-5000 * Front transverse slide operator group

Abrasive belt size 150x5000 m.

Linear blowers for belt cleaning

PE 32T Electronic clutch/separator "EPICS"

15kW motor controlled by INVERTER

Automatic brake

2nd OPERATOR GROUP

KRP 150-2620 Combined operator group for roller diameter 150 mm and grinding roller

Caliper/planer roll

RA-150 Spline steel roller

PE 32/L Electronic subdivided hinge "EPICS" pass 32 mm.

Oscillating blowers timers for abrasive belt cleaning

Motor 18.5 kW inverter-controlled

Pneumatic ON-OFF for positioning

Abrasive belt size 1370x2620 mm.

Automatic brake

3° OPERATOR GROUP

S-2620 Operator group for superfinisher slipper

PE 32/L electronic cam, EPICS stepped 32 mm.

Abrasive belt size 1370x2620 mm.

15 kW motor controlled by INVERTER

Oscillating blowers timers for abrasive belt cleaning

Total management of its functionality from control

4th OPERATOR GROUP

SB/U Oscillating operator unit for abrasive cloth roll with a diameter of 200 mm.

SB 200 UFC Wheel with abrasive cloth of diameter 200 mm. type "Ultra Fine" with silicon carbide fibers

SRP-U Rotating blow-off group with piece cleaning timers

DEVICES FOR COMPACT INLINE MACHINE

Machine in compact end-of-line version

Base T4M with fixed-height ground work surface of 900 mm